A socket made in ReMould, black, standing on a dark stage. Render.

A screen recording of ReMould designing a forearm socket: the scan is imported and aligned, the landmarks are marked, the wall is adjusted on a colour fit map, the trim line is set, and the socket is built, reviewed and exported.

A socket made the usual way takes weeks.

The cast becomes a mould, the mould is scanned, the scan becomes a model, and the model is printed. The patient comes back at each step.

How it works

ReMould takes the same job through six steps.

  1. Import scan

    Bring in a 3D scan of the residual limb, and ReMould lines it up along the limb.
  2. Landmarks

    Mark the bony landmarks that every adjustment is placed from.
  3. Rectify

    Push the wall in where the socket should bear load and out where it needs relief, and see each change on a colour fit map.
  4. Trim lines

    Set where the edge of the socket sits, and pull the line up or down around the joint.
  5. Generate socket

    ReMould builds the socket wall around the rectified shape and adds the attachment for the hand.
  6. Check and export

    Check the finished socket, approve it, and export the file for printing.

Clinical evaluation programme

It starts with cases you have already completed, before any patient is involved.

  1. Demonstration

    We walk your team through ReMould on real cases.
  2. Retrospective evaluation

    You share three anonymised scans from completed cases. ReMould designs a socket for each, and you compare them against what you fitted.
  3. Paired check socket

    ReMould's design is fabricated as a check socket alongside your own.
  4. Clinical pilot

    Limited use of ReMould in your clinic, under your clinical judgement.

Join the clinical evaluation programme.

Does your clinic have a 3D scanner?
Does your clinic have a 3D printer for sockets?

Privacy notice, opens in a new tab

Replies come from [email protected].

What we supply, and what the clinic does.

The prosthetist makes every decision about fit.

ReAble supplies

  • The hand
  • ReMould
  • Replacement fingers

Your clinic does

  • The scan
  • The socket print
  • The fitting
  • The relationship with the patient
A socket made in ReMould on a desk, beside a keyboard. Render.

There are two ways to use ReMould.

Design licence
For clinics that already print.
Design plus printer
For clinics that do not print yet.

ReMould is in development and has not been approved by any regulatory authority.